ExpertLotto.com

I created a Complex Filter for Carbob for Base Digit Numbers that contain the digits 1, 2, and 3


I may have entered the wrong "Matching Tickets" settings. When I ran the program to filter the combination's in the Package I still have the number 11, 22, 33 still in the package. I then added a 4th "Matching Numbers" filter to reject the numbers 11, 22, 33 but these numbers show up in the filtered set in the image below.

i think you didn't re-run the complex filter after adding the 4th subfilter.
the first screenshot shows that in preview the whole filter accepted 14440 tickets and that seems to be correct. i've recreated the same filter and the same results. there were no tickets with a single number 11, 22 or 33 left after filtering.

however the second screenshot shows that 20848 ticket are left in the package, including tickets with numbers 11, 22 or 33.

Hi Stan. Thanks for your reply. I re-ran the Complex Filter from the beginning and still end up with 14,400 combination's and the combination's the 11, 22, and 33.

Would it be possible to place a screen shot of your filter settings?

Thanks so much!!

winsumloosesum wrote:Hi Stan. Thanks for your reply. I re-ran the Complex Filter from the beginning and still end up with 14,400 combination's and the combination's the 11, 22, and 33.

Would it be possible to place a screen shot of your filter settings?

Thanks so much!!

I come up with 14,171 combos. Here's my screenshot. I have the reject filter set to match 3,2,1.

winsumloosesum wrote:Hi Stan. Thanks for your reply. I re-ran the Complex Filter from the beginning and still end up with 14,400 combination's and the combination's the 11, 22, and 33.

Would it be possible to place a screen shot of your filter settings?

Thanks so much!!

note that with your filter settings you'll get tickets with two or three numbers 11, 22 and 33. but there never will be a ticket with just a single number 11, 22, 33.
if you want to remove tickets that contain any such number(s) then the last filter in your complex filter must have parameters of 'match 1,2,3 numbers from 11,22,33'

Hi Stan,

Thanks for the information. I see what your saying. I changed the filter setting and re-ran and it did filter all the 11, 22, 33 from the package.

Thanks so much for all your help!!