Hi Stan
I have noticed the following two related issues. Unfortunately their behavior is not consistent in that they do not occur every time the following procedure is followed.
1). Open EL and load a full package. Go to WNH. The bottom line may be populated with simulator results (simulator using its default setting of 123….) although the simulator button was not pressed. The problem goes further because pressing on the simulator button to try and deactivate it does no good since it was not pressed in the first place.
2). Open EL. Load full package. Go to WNH. Assume simulator did not automatically activate this time. Run Predictor. On some occasions it will insert the simulator line automatically above the predictor line – although the simulator was not run.
Thanks for your attention.
Bobijohn