stan wrote:teoman wrote:Hi, Stan,
Thanks very much for implementation 'limit range for simulation estimates', but it would have been even more extraordinary if the percentages it would be was with decimal, could be use more levels, thousands, so 1% is effective only up to 100 levels.
I hope not is too difficult for you to do and this improvement.
the occurrence threshold relates to the occurrency of the most frequent value in the simulation. so if the most frequent simulated sum has occurrence of 1000, then settings 2% to 3% of maximum frequency will select sums that have occurrence of at least '20' on the left hand part of the histogram and '30' on the right hand part of the histogram.
it'll be described properly in updated documentation when version 5.1 is released officially
Stan, I understand how it works, but if I want to use thousands of levels, I not can make an effective setting, especially on the left side aimed at negative values, which would be was desirable to have values of percentages with decimal. With 1% not can reduce the negative values with 5% -10%. Here are a few percent of the values that you see in the image, to 1% all is reduced with too much, with over 24%:
(-58) - (-43) = 15 => 25,86%
(-63) - (-43) = 20 => 31,75%
(-48) - (-28) = 20 => 41,66%
(-59) - (-44) = 15 => 25,42%
(-81) - (-56) = 25 => 30,86%
(-70) - (-48) = 22 => 31,43%
(-116)-(-80) = 36 => 31,03%
(-85) - (-57) = 28 => 32,94%
(-82) - (-53) = 29 => 35,37%
(-92) - (-70) = 22 => 23,91%
(-50) - (-34) = 16 => 32,00%
(-62) - (-41) = 21 => 33,87%
(-105)-(-75) = 30 => 28,57%
You do not have the required permissions to view the files attached to this post.